對濟南鋁卷http://www.pdadn.com/進行裁剪是合金鋁卷生產或使用的必經過程，而硅對硬質合金有腐蝕作用，雖然一般將超過12%Si的鋁合金稱為高硅鋁合金，因此在生產濟南鋁卷時，一般廠家推薦使用金剛石刀具，但這也不是絕對的，硅含量逐漸增多對刀具的破壞力也逐漸加大，硅含量在8%至12%之間的鋁合金是一個過渡區間，既可以使用普通硬質合金，也可以使用金剛石刀具。
Jinan is an alloy of aluminum coil aluminum coil cropping production or use of a necessary process, and silicon carbide have a corrosive effect on, although most will be more than 12% Si is called high-silicon aluminum alloy, so the production of aluminum in Jinan when the volume is generally recommended to use a diamond tool manufacturers, but this is not absolute, silicon content gradually increased the destructive power of the tool is gradually increasing silicon content aluminum alloy between 8-12% is a transition zone, either use ordinary carbide, diamond tools can also be used.
   
使用硬質合金制作濟南鋁卷http://www.pdadn.com/時，應使用經PVD方法、不含鋁元素的、膜層厚度較小的刀具，因?yàn)镻VD方法和小的膜層厚度使刀具保持較鋒利的切削刃成為可能，而膜層材料含鋁可能使刀片膜層與工件材料發生親合作用而破壞膜層與刀具基體的結合，因?yàn)槌插儗佣酁殇X、氮、鈦三者的化合物，可能會因硬質合金基體隨膜層剝落時，少量剝落造成崩刃。
When using cemented carbide production Jinan aluminum coil, should be used by the PVD method, free of aluminum element, the smaller film thickness the tool, because the PVD methods and a small film thickness so that the tool holding

relatively sharp cutting edge as possible, the film material is an aluminum-containing layer may make the blade with the workpiece material and damage occurring binding affinity for the substrate film and the tool, because more ultra-hard coating of aluminum, nitrogen, titanium three compounds, may be due to carbide when coating substrates with peeling, flaking caused a small amount of chipping.